PIP-3048LV – MK – Zero Transfer Time

(1 customer review)


5 in stock

Categories: , ,



Off Grid Inverter

Beware of Fake Chinese copies, or buying from overseas may save you a few bucks, this also buys you ZERO support from Sum Ting Wong land, returns/warranties need to be sent back overseas at your cost – but feel free to do as you please.

Brand new model.  Stackable to 9 units , thats 27kW in Split Phase, Single Phase, Two Phase or Three Phase output (Three phase requires at least 3 units)

Featuring Zero Transfer time.  In other words, when it switches from utility to Inverter in either direction, there is zero time delay.  Basically, Even when charging via utility it is always powering your load via the inverter, filtering any Grid Noise or spikes to your load No interruption

Parallel kits NOT Included, purchased separately

NO GRID FEEDBACK!! – Does and can not feed excess solar energy back to the grid,  only the Hybrid LV2424 has this feature

All-In-One unit: (Solar MPPT, Inverter, and Utility/Generator Charger)

REQUIRES A 48V BATTERY TO OPERATE – NO BATTERY = NO WORKIE!  Voltage needs to be above 47V to turn on – cold start  (safety feature) Recommended 200AH Max Voltage is 64V

3kW 120Vac 60Hz Pure Sine inverter output

80A MPPT Charge controller , up to 4Kw of Solar input  (60 to 115V DC Vmp)

Built in UPS / Power transfer as explained above

Stackable up to 9 units in any config

Max Utility charging current = 60A

Dry Contact Relay Programmable  (Start a Generator or do something when battery is charged or discharged)

USB Cable and port with included software (Watchpower)

Lithium ION and All Lead Acid battery compatible – also has a USER battery type you can program it

Any other questions, ask away!

Its basically half a LV5048 plus 20% more power

Additional information

Weight 30 lbs
Dimensions 23 × 16 × 8 in

1 review for PIP-3048LV – MK – Zero Transfer Time

  1. Preston

    I installed this inverter in early July 2020. The mpp charge controller works amazing it has no problems with 2.8 KW of PV. The inverter is low 90% efficient. I state that using an inductive amp clamp while doing the math. It is a relativity quiet unit. There is a .45A draw all of the time even if the inverter is switched off. It switches to and from commercial power without even flickering a light. My only real complaint is with the programming of the unit. It is easier to program with a computer, If I could drain batteries to a set voltage the switch to commercial power without using commercial power to recharge batteries that would be amazing.

Add a review

Your email address will not be published.